GYS BATIUM 7/12 Manual De Instrucciones página 11

Ocultar thumbs Ver también para BATIUM 7/12:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
Translation of the original instructions
The battery is connected.
The charge indicator 1 does
not switch on. The battery
3
voltage indicators and bat-
tery capacity indicators are
switched on.
The indicator light «SOS
Recovery» (Batium 15.12
4
et 15.24) flashes after one
minute of charge.
SOS RECOVERY (Batium
15.12 / 15.24) : after 24
5
hours, the charge and end of
charge indicators are swit-
ched off.
Forced charge : After pressing
the battery voltage button
6
during 5 seconds to start the
forced charge, the indicator
does not switch on.
When connecting to the
7
mains, no indicator switches
on
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
BATIUM 7/12 • 7/24 • 15/12 • 15/24
Polarities + and – are reversed
Bad clamp connections.
The battery is deeply discharged.
The fuse is melted.
The battery has suffered a deep
discharge over a long period, with
a start in sulfation. . The charge
continues but it is recommended to
switch to « SOS recovery ».
Battery cannot be recovered
Battery voltage < 0.5 V (± 0.3)
Put the red clamp at the + the black
clamp at the -
Clean the terminals and reconnect the
clamps.
Use the « forced charge » mode (see
the procedure on the previous page)
Disconnect the machine from the mains.
Remove the clamps from the battery.
Replace the fuse with regard to its size
(15 A for a Batium 7-12 7-24 or 30 A for
a Batium 15-12 and 15-24).
Disconnect the machine from the mains,
then the clamps. Activate the « SOS
Recovery » mode, see the previous
page.
Battery to be replaced
Battery to be replaced
Disconnect the Batium from the mains
during 10 sec., then reconnect it.
EN
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Batium 15/12Batium 7/24Batium 15/ 24

Tabla de contenido