Luminance Brands Kathy Ireland Home LK500 Serie El Manual Del Propietario página 12

4. Installation on Luminance Brands Fans Having
Two-Piece Die-Cast Switch Housing (continued)
4.9
NOTE: The FN200 pack comes with three bowl cap
options: no holes, one hole and two holes for pull
chain options.
Place the Bowl Cap (for your application) onto the Light
Fixture Assembly Threaded Shaft .
Route the Fan Speed Control Chain through the Bowl
Cap Outer Hole .
Route the Light Fixture Assembly Control Chain
through the Bowl Cap Center Hole (Figure 19) .
Install and tighten the Finial Nut onto the Light Fixture
Assembly Threaded Shaft (Figure 19) .
NOTE: It is critical that the fan chain(s) are aligned
with hole(s) in the shade and bowl cap for smooth
operation of the fan switch(es).
4.10
Connect the Pendant (supplied) to the Fan Speed
Control Chain by sliding the Pendant (small hole first)
up onto the Fan Speed Control Chain (Figure 20) .
Then attach the Coupling (supplied) to the end of the
Fan Speed Control Chain and allow the Pendant to fall
down over the Coupling (Figure 20) .
Connect the Pendant (supplied) to the Light Fixture
Assembly Control Chain by sliding the Pendant (small
hole first) up onto the Light Fixture Assembly Control
Chain (Figure 20) .
Then attach the Coupling (supplied) to the end of the
Light Fixture Assembly Control Chain and allow the
Pendant to fall down over the Coupling (Figure 20) .
THREADED
SHAFT
BOWL CAP
LIGHT FIXTURE
ASSEMBLY
CONTROL CHAIN
Figure 19
LIGHT FIXTURE
ASSEMBLY
CONTROL CHAIN
Figure 20
12
SHADE
OUTER HOLE
CENTER HOLE
FINIAL NUT
FAN SPEED
CONTROL CHAIN
SHADE
FAN SPEED
CONTROL CHAIN
PENDANT (2)
COUPLING (2)
U.L. Model No.: LK500