ICA Turbojet PLUS Manual De Instrucciones página 19

Installation instruction:
8. Assemble valve base
open
Replace the valve base in its position, make sure the valve base handle is
in the "unlock" position.
10. Assemble flexible tube
Inlet
Outlet
pipe
pipe
Elbow
Tubing
Connect the tubing to the inlet and
outlet pipes, at least 3cm depth.
13. Set up inlet pipe
Introduce the inlet pipe in the tank,
fix the pipe with a suction cup.
The strainer must be below the
minimum water level.
lock
11. Assemble shower pipe/
directional spout
Tubing
*Method 1: connect the shower
pipe to the outlet pipe.
*Method 2: connect the directional
spout to the outlet pipe.
14. Set up the valve tap hose
Out
In
Connect the inlet tubing to the
valve marked with "in" and outlet
tubing to the valve mark with
"out". Tighten the tubing with the
screws.
9. Lock valve base
When the valve base is set to
position, push the valve base
handle back to the "lock" position.
12. Set up outlet pipe
Fix the spray bar in position with
suction cups.
15. Pumping
Screw
Grasp the pumping handle and
move up and down 2-4 times,
then the water in the tank will be
sucked into the canister. *The
distance between the aquarium
edge and the water level should be
under 12cm.
lock
12cm
19