Troubleshooting - Angelcare AC315 Manual Del Usuario

IMPORTANT
• If you have a Sensor Pad connected to your Angelcare Monitor, it can ONLY be paired
with Camera 1. The alarm on the Parent Unit will only sound if Camera 1 is selected or
in split view. If another Camera is selected only the Camera 1 will sound the alarm.
• You will only be able to hear audio from one camera at a time. When in split screen,
the sound transmitted from the Parent Unit will be from the Camera number
highlighted in the info bar.

TROUBLESHOOTING

TAKING CARE OF YOUR RECHARGEABLE BATTERY
• Ensure that you fully charge your battery for 9 hours before its first use.
• To maintain maximum battery life it is recommended that you fully discharge your battery periodically.
If your Parent Unit is not in use, please turn it OFF.
LOSS OF CONNECTIVITY
• If your Camera becomes un‑paired from your Parent Unit, please follow the steps below to re‑pair them.
18°C
18°C
6
NO SOUND IS BEING TRANSMITTED
• Check the volume level on the Parent Unit and the Camera to ensure they are set to an appropriate level.
• Try bringing the Parent Unit closer to the Camera to see if you get sound.
• Charge the Parent Unit.
WEAK RECEPTION
• Bring units closer together.
• Change the position of one or both units.
• Place units on a flat surface away from baby's reach.
• Recharge the Parent Unit.
STATIC, DISTORTION, INTERFERENCES
(FROM OTHER MONITORS, WIRELESS PHONES, WALKIE‑TALKIES, ETC.)
• Rotate Parent Unit or move it away from source of interference.
FEEDBACK (LOUD NOISES EMITTED FROM THE PARENT UNIT)
• Move units farther apart (at least 3 metres).
• Decrease volume on Parent Unit.
241AC_10_AC315_EU2_M2.indd 77
1) Select the pairing settings menu and then
2) Press the down arrow
highlight CAMERA (the Edit icon will turn to blue).
Press
appears, and then Press
will appear, then Press
3) Plug in and turn your Camera ON.
4) Press and hold the Pause/Pairing button on the top
right of the Camera for 2‑3 seconds.
5) When the Trash can icon
now paired.
3
once and press
to delete the paired camera as the Trash icon
to confirm. The
to re‑pair the camera.
The Parent Unit Power Indicator will flash to
indicate it's in linking mode.
shows up, the Camera is
E
N
to access it.
to select/
icon
77
2018-02-26 1:34 PM