Kohler STERLING SP5300 Serie Manual Del Usuario página 9

Bumper
#8-18 x 2" Panhead
Screw
7. Install the Wall Jambs
Place a wall jamb over the bottom track. Align the holes in the wall jamb with the holes in the wall.
NOTE: The top and bottom screws should be inserted through bumpers before being installed. Do not
overtighten the screws or damage to the bumpers may occur.
Secure the wall jamb to the wall with three #8-18 x 2" panhead screws.
Repeat the procedures with the other wall jamb.
8. Install the Top Track
NOTE: The top track is designed so either side may be positioned facing outward according to your
preference.
Measure the distance from wall to wall at the top of the wall jambs.
Mark the top track at the determined dimension.
NOTE: For best results use a 32-teeth per inch hacksaw and miter box.
Cut the top track on the inside edge of the mark [approximately 1/32" (1 mm) from the mark] to
allow space for the top track to slide into place easily.
Carefully file the rough edges smooth where the top track was cut, taking care to avoid damaging
finished surfaces.
Position the top track over the wall jambs and gently push down.
Sterling 9
Top Track
Measure here.
1034037-2-B