Blackmagic Design Fairlight Manual De Instrucciones página 10

To attach the legs to the console chassis:
1 Remove the side cover from each leg by unscrewing the four M3 screws from the
opposite side of the leg using a Pozidriv 2 screwdriver.
2 Remove the four M12 leg fastening screws from each side of the console chassis.
3 Align each leg to the side of the console by mounting it against the guide pins on
the chassis.
4 Secure the legs to the chassis with the leg fastening screws and tighten the screws to
a torque of 35 Nm.
The side cover for each leg can be reattached later. Leaving the cover off at this point
of assembly provides access to the inside of the leg for when you are wiring up the
panels inside the console.
5 Carefully lower the console from the support surface and place it on the floor.
We recommend placing the assembled chassis as close to its intended position as
possible, as once Fairlight modules are installed, the overall weight of the unit will
increase substantially. Ensure there is enough space at the rear of the chassis to
replace the back panel before securing your console into position.
Unpacking and Assembling 10