Blackmagic Design Fairlight Manual De Instrucciones página 9

To attach the foot to each leg:
1 Lay the leg on its side with the cover panel facing upwards. Remove the
two M12 screws from the end including the small support plate.
After removing the support plate from the standard 0 degrees
leg kit, it is then used to secure the foot to the leg
NOTE If you are attaching the 8 degrees leg kit, be sure to keep the support
plate between the foot and the leg. An additional support plate is used to
secure the foot to the leg, as shown below.
2 Align the foot to the end of the leg and hold it in place. Make sure the rectangular
cut outs on the bottom of the leg and support plate are completely aligned.
3 Now place the support plate on the bottom of the foot and secure the
foot to the leg using the two M12 screws. Tighten to a torque of 35 Nm.
4 Repeat steps 1 to 3 for the second leg.
Unpacking and Assembling 9