Connecting The Fairlight Modules - Blackmagic Design Fairlight Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 119

Connecting the Fairlight Modules

After installing the Fairlight modules and plugging in power, connect each module to the other
using an Ethernet daisy chain. It doesn't matter which particular unit is connected to the other,
as long as they are all connected via their Ethernet ports.
If you would like to use an Ethernet switch to connect the modules, this is ok and just place
the Ethernet switch inside the console where there is lots of space. Then you can connect each
panel module to the switch directly.
Below is an example of how you could connect the Fairlight modules in a daisy chain.
HDMI
Ethernet
TIP
We recommend using 1.2 meter Cat6 Ethernet cables. These will allow you to
lift the panel brackets after installation without stretching the cables.
CONTROL ROOM
STUDIO
Computer
Unpacking and Assembling
17

Publicidad

Tabla de contenido
loading

Productos relacionados para Blackmagic Design Fairlight

Tabla de contenido