Switch From Bike 1 To Bike; Service Interval Display; The Navigator - VDO X Serie Instalacion Y Operación Manual

D GB F I
You can set the flashing digits
using .
To access the next digit, con-
firm with M . Repeat the steps
until the last digit on the right
is flashing. Confirm with
5.5 Switch from Bike1 to Bike2
Your VDO computer can be used on 2 bikes.
If you switch from bike 1 to bike 2, the computer
recognises the transmitter from bike 2. The
computer then automatically switches to bike 2.
All data are now saved for bike 2. When you use
the computer again on bike 1, transmitter 1 is
recognised. The computer switches to bike 1.
The data are now saved for bike 1.

5.6 Service interval display

The VDO service interval display reminds you to
have your bike checked in the workshop.
You can switch the service interval ON or OFF.
You can set separate service intervals for 2 bikes
When the set service interval distance has been
reached:
The -symbol flashes on the display.
B
The information line displays
B
BIKE SERVICE/BIKE 1
You should now either carry out the recommend-
ed bike check yourself or have the bike checked
by your dealer.
38 X2DW
ODO BIKE 1/SET OK? Confirm with
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
M .
The selected Bike 1 or 2 is shown
on the display bottom left (
Note: The transmitter on bike 2 must have been
set to bike 2 before using it the first time.
Press any button. The text BIKE SERVICE disap-
pears again. After another 50 km the
appears. You can also switch off the flashing
symbol. To do so, enter the service interval again.
How to set the service interval:
Using go to SETTINGS/
SELECT. Confirm with
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
VDO CYCLECOMPUTING
.
M
Using
SET. Confirm with
>>> P03
BIKE SERVICE/ON (switch to OFF
using
).
BIKE SERVICE/BIKE 1
(use
>>> P03 Confirm with

5.7 The navigator

With the VDO navigator you can complete trips
-also dis- according to Roadbooks. Roadbooks = tour
descriptions with km information for certain
points of orientation. The VDO navigator is an
independent km counter and can count forwards
or backwards. The km status can be set at any de-
sired point. You can therefore start in the middle
of a trip or make a km correction if you have taken
M . a wrong turn.
www.vdocyclecomputing.com
go to BIKE SERVICE/
M .
Repeat the steps until the last digit on the right
is flashing. Confirm with
BIKE 1/SET OK? Confirm with
). Confirm with M .
The display confirms: BIKE SERVICE/SET DONE.
Automatic return to SETTINGS/SELECT.
to switch to bike 2)
M .
Setting the navigator:
I F GB D
BIKE 1 ...SET DISTANCE/
CONTINUE. You can set the flash-
ing digits using To access
the next digit, confirm with M .
M .
M .
Using go to NAVIGATOR/
SELECT. Confirm with M .
NAVIGATOR/SET. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
X2DW 39