Regulatory information
FCC COMPLIANCE NOTICE
This device complies with part 15 of the FCC rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly approved by
the party responsible for compliance could void the user's au-
thority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following meas-
ures:
X Reorient or relocate the receiving antenna.
X
X Increase the separation between the equipment and receiver.
X
X Connect the equipment into an outlet on a circuit different
X
from that to which the receiver is connected.
X Consult the dealer or an experienced radio/TV technician for help.
X
WEEE DIRECTIVE
If the time arises to throw away your product, please recycle all the
components possible.
This symbol indicates that when the end-user wishes
to discard this product, it must be sent to separate col-
lection facilities for recovery and recycling. By sepa-
rating this product from other household-type waste,
the volume of waste sent to incinerators or land-fills
will be reduced and natural resources will thus be con-
served.
The Waste Electrical and Electronic Equipment Directive (WEEE
Directive) aims to minimise the impact of electrical and electronic
goods on the environment. Powersoft S.p.A. comply with the
Directive 2002/96/EC and 2003/108/EC of the European Parliament
on waste electrical finance the cost of treatment and recovery of
electronic equipment (WEEE) in order to reduce the amount of WEEE
that is being disposed of in land-fill site.
All of our products are marked with the WEEE symbol; this indicates
that this product must NOT be disposed of with other waste. Instead
it is the user's responsibility to dispose of their waste electrical and
electronic equipment by handing it over to an approved reprocessor,
or by returning it to Powesoft S.p.A. for reprocessing. For more infor-
mation about where you can send your waste equipment for recy-
cling, please contact Powesoft S.p.a. or one of your local distributors.
EC DECLARATION OF CONFORMITY
Manufacturer:
Powersoft S.p.A.
via E. Conti 5
50018 Scandicci (Fi)
Italy
We declare that under our sole responsibility the products:
Model Names:
X8, X4, X4L
Intended use: Professional Audio Amplifier
Are in conformity with the provisions of the following EC
Directives, including all amendments, and with national legisla-
tion implementing these directives:
X 2006/95/EC Low Voltage Directive
X
X 2004/108/EC Electromagnetic Compatibility Directive
X
X 2002/95/CE RoHs Directive
X
The following armonized standards are applied:
EN 55103-1
EN 61000-3-2
EN 61000-3-3
EN 55103-2
EN 61000-4-2
EN 61000-4-3
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-11
EN 60065
Scandicci,
July 2014
For compliance questions only: compliance@powersoft.it
P
Luca Lastrucci
Managing Director
X Series | 15