Maintenance And Cleaning; Wear Parts - Oase AquaMax Eco Classic 2500 Instrucciones De Uso

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
− Prior to reaching into the water, disconnect the power supply to all units used in the water.
− Disconnect the power plug prior to carrying out work on the unit.
Cleaning the unit
If necessary, clean the unit with clear water using a soft brush.
− Never use aggressive cleaning agents or chemical solutions. These could attack the housing surface or impair the
function.
− In the event of stubborn furring (calcium deposits), a common household cleaner free from vinegar and chlorine can
be used. Subsequently, clean the pump thoroughly using clear water.
Aquamax Eco Classic 2500
− In the event of the filter housing capacity reducing, clean the unit under running water using a brush.
Clean pump
8.
0.
How to proceed:
G
1. Screw off the stepped hose adapter.
2. Remove screws.
− The screws are used as transport protection and not required for operation.
3. Actuate the engagement hook and fold up the strainer top casing.
4. Remove pump.
5. Unscrew the pump housing and pull out the impeller unit.
− Clean all components under running water using a soft brush, replace damage parts.
6. Reassemble the unit in the reverse order.
− Place the pump cable into the cable opening of the bottom strainer casing such that the cable will not be crushed
when closing the filter housing.
Aquamax Eco Classic 3500/5500/8500/11500/14500
− In the event of the filter housing capacity reducing, clean the unit under running water using a brush.
Clean pump
7.
0.
How to proceed:
H
1. Screw off the stepped hose adapter.
2. Remove screws.
− The screws are used as transport protection and not required for operation.
3. Actuate the engagement hook and fold up the strainer top casing.
4. Remove pump.
5. Remove screws.
6. Remove the pump housing including its holding ring, sealing and impeller unit.
− Clean all components under running water using a soft brush, replace damage parts.
7. Reassemble the unit in the reverse order.
− Place the pump cable into the cable opening of the bottom strainer casing such that the cable will not be crushed
when closing the filter housing.

Wear parts

The impeller unit is a wearing part and does not fall under the warranty.
- GB -
13