Rockford Fosgate RFQ5000 Manual De Instrucciones página 12

Wiring the System
NOTE: The B+ lead of the audio system MUST be fused 18" or less from the vehicle's battery.
Install a fuseholder, along with the necessary fuse, under the hood. Connections should be
water tight.
The REM lead should be connected to the remote turn-on or power antenna output from the
source unit. Prepare a length of cable from the source of switched voltage by stripping 3 / 8 " of
insulation from the end of the wire. Insert the bared wire into the REM terminal of the power
connector and fasten the screw. Total current consumption through this lead is negligible.
The GND lead should be connected to the chassis ground of the vehicle. Prepare a length of
cable (approximately 12" long) to be used for the ground lead by stripping 3 / 8 " of insulation
from each end. Insert one end of bared wire into the GND terminal of the power connector
and fasten the screw. Prepare the chassis ground by scraping any paint from the metal surface
and thoroughly clean the area of all dirt and grease.
Strip the other end of the wire and attach a ring connector. Fasten the cable to the chassis
using a non-anodized screw and star washer.
2. Connect the Source Inputs
Connect the front RCA outputs from the source unit to the "LEFT FRONT IN" and "RIGHT
FRONT IN" connectors on the RFQ5000.
Refer to page 3 "Panorama Control" for details on rear inputs.
3. Connect the Outputs
Connect the appropriate outputs from the RFQ5000 to the corresponding inputs on the amplifi-
er(s) or signal processor(s).
11