Cutting Procedures Using 32V Vise; Special Procedures; Changing Saw Blades - RIDGID 932VS El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

932VS Portable Band Saw
Figure 7A
A. Insert mounting bracket pin through hole in work vise
(Figure 7A).
B. Install safety clip and gently lower saw until it rests on
workpiece (Figure 7B).
Safety clip must be installed to prevent
WARNING
separation of band saw from work vise during operation.

Cutting Procedures Using 32V Vise

Make sure band saw trigger switch is in
WARNING
OFF position. Connect saw to power source. Only use
the vise at heights where a firm grip can be maintained
on the saw handle throughout the cut.
1. Grasp band saw handle and lift so blade is clear of
workpiece.
2. Depress trigger switch to start saw. Make any nec-
essary speed adjustment.
Figure 8
3. Slowly lower saw until blade engages work. Maintain
a firm grip on saw handle while saw completes the
cut under its own weight. DO NOT FORCE the saw
through the workpiece. Support saw weight as cut is
completed.
Figure 7B
Ridge Tool Company
NOTE! During the first cut; the index pin (Figure 8) will
also be cut OFF. On subsequent cuts, the index
pin is used to accurately position the vise to the
workpiece so that the cut will follow a predeter-
mined line.
4. As soon as the cut is completed, release trigger
switch and disconnect saw from power source.
5. Remove safety clip and lift saw from work vise.
6. Release clamp and remove work vise from work-
piece.
NOTE! It may be necessary to add shims (see Figure 9)
between the bracket and the saw to produce a
90° cut. See the following instructions: Shim
washers are supplied in the hardware package.
Figure 9

Special Procedures

Changing Saw Blades

Make certain that power cord is un-
WARNING
plugged before changing blade.
Direction of blade travel on left
side of saw.
Position of teeth on left side
of saw.
Figure 10 – Correct Positioning of Saw Blade.
1. Turn blade tension handle at front of saw 180 degrees
clockwise so it points FORWARD to release tension
on saw blade.
2. Remove blade, first from pulleys and then from guides.
3. Insert replacement blade between rollers and faces
of guides.
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

32v

Tabla de contenido