Dräger Polytron 6100 EC WL Instrucciones De Uso página 48

en |
Troubleshooting
C: Function Check
O: Outside of specification (Out of Specification)
M: Maintenance required (Maintenance Required)
Bit DIAG_STATUS
31 F: Failure
30 C: Function Check
29 O: Out of specification
28 M: Maintenance required
27 FAULTS_ELECTRONICS
26 FAULTS_SENSOR
25 INSTALLATION_CALIBRATION
24 OUT_OF_SERVICE
23 OUTSIDE_LIMITS
22 ENVIRONMENTAL
21 FAULT_PREDICTION
48
General status Cause
– –
– –
– –
– –
F Serious device fault, various causes.
F Sensor not detected or defective.
For the activated sensor lock feature, a
sensor with a different part number was
inserted.
C Calibration or bump test active.
C Start sequence active.
Start sequence failed.
O Measured value below range.
O Device is operated outside the specified
temperature range.
M Device warning
Instructions for use |
Dräger Polytron
Remedy
–
–
–
–
A Restart the device.
B Reset device to factory settings.
C Update firmware.
D Have the gas detector checked by
DrägerService.
A Check the sensor connection.
B Remove and reinstall the sensor.
C Change the sensor.
D Insert sensor with the correct part num-
ber.
Finish calibration or bump test.
Wait for start sequence.
A Restart the device.
B Have the gas detector checked by
DrägerService.
A Calibrate the sensor.
B Change the sensor.
Use weather protection kit (accessory)
when exposed to sunlight.
A Check ISA100 Wireless
B Check detail status with PolySoft.
®
6100 EC WL, Dräger Polytron
™
connection.
®
Repeater ISA