Verilux VTi CELTIC Manual De Programación página 4

Setting traversing limits
Before starting...
The 2 buttons (red and blue)
unlocked (fig. 2).
The buttons are unlocked when they "click" once pressed. If both
buttons or at least one is locked, follow the procedure to reset the
motor to factory default settings
The carriers must be aligned and spread out to approximately the
middle of the track so that not all the slats are stacked to one side.
To do this, remove the track
CHAIN manually until the carriers are approximately in the middle of
the track (fig. 3).
Then place the GEAR
DRIVE CHAIN
1
2
on the traversing motor must be
(pp. 8-9).
COVER, remove
back.
MOTORS
3
4
Fig.
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
GEAR 1 and pull the drive
GEARS
3. Motor side
Fig. 2. Limit setting buttons
TRACK
COVER
vertilux.com
3