Verilux VTi CELTIC Manual De Programación página 7

2. Press and hold the blue button
step 4.
3. On the wall control, press either
button. If the button you pressed does not make
the carriers rotate, try the opposite
direction button. Press the
carriers are aligned and set at
(fully closed position) (fig.
direction button
Remember which
this step.
4.
You can now release the
5. On the wall control, press the
direction button
to make the carriers return to
the original starting position at 90° of the rail,
4).
(open position) (fig.
The first tilting limit has now been set.
6. red button
Press and hold the
step 8.
7. Press the opposite direction button
selected in step 3.
The slats will rotate to the opposite direction of
the first tilting limit that was set.
stop button
Press the when the slat is aligned
and set to 0° of the track
8. You can now release the
On the wall control, press the same
button
as selected in step 3.
The other tilting limit has now been set.
vertilux.com
6
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
until you reach
direction
stop button when the
0° of the track
5)*.
you selected in
blue button.
opposite
until you reach
of the one
(fig. 5)*.
red button.
direction
DIRECTION BUTTON
OPPOSITE DIRECTION
OPPOSITE DIRECTION
BUTTON
TILTING MOTOR
RED BUTTON
TILTING MOTOR
BLUE BUTTON
STOP BUTTON
TILTING MOTOR
BLUE BUTTON
BUTTON
TILTING MOTOR
RED BUTTON
STOP BUTTON
DIRECTION
BUTTON