Verilux VTi CELTIC Manual De Programación página 5

1. Set DIP switches No. 2
position
to set the traversing limits.
2. blue button
Press and hold the
step 4.
3.
On the wall control, press either
button. If the button you pressed does not start
the traverse movement of the carriers, try the
direction button.
opposite
Press stop button when the carriers reach the
first desired limit at one side of the track*.
Remember which direction button
this step.
4.
You can now release the
5.
On the wall control, press the
direction button of the one selected in step 3, this
will bring the carriers to the initial position (in the
middle of the track) in which they first were.
The first traversing limit has now been set.
6. red button
Press and hold the
step 8.
7. On the wall control, press the
direction button
of the one selected in step 3.
Let the motor move and press the
when the slats reach the second traversing
desired limit.*
vertilux.com
4
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
and No. 4 in the ON
until you reach
direction
you selected in
blue button.
opposite
until you reach
opposite
stop button
1 2 3 4
DIP
DIRECTION BUTTON
TRAVERSING MOTOR
OPPOSITE DIRECTION
OPPOSITE DIRECTION
BUTTON
ON
TRAVERSING MOTOR
BLUE BUTTON
STOP BUTTON
BLUE BUTTON
BUTTON
TRAVERSING MOTOR
RED BUTTON
STOP BUTTON