Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Resetting the motor to factory default
If you need to reset the traversing motor
No. 2
Set DIP switches
GEAR 1
Remove
to release the chain. To do this, remove the track
Follow the procedure described in either
These procedures apply for the traversing as well as the tilting motors.
If you need to reset the tilting motor
Set DIP switch
No. 4
in the
Remove
GEARS
1,
2
and
Follow the procedure described in either
These procedures apply for the traversing as well as the tilting motors.
Case #1:
Both motor buttons, the blue and the red one, do not "click" when pressed.
wall control
1.
On the
direction button
until the motor stops on its own.
If the button you pressed does not start the
motor, or if after several minutes the motor does
not stop, try the opposite direction button.
Remember which
direction button
this step.
2.
Press the
stop button
3.
Test the
red
and
blue buttons
point, one of them should be able to make a
"click" sound. That button is now unlocked.
4.
Press and hold the button that is unlocked on
the motor until you complete step 5. On the wall
button
control, press the
to that selected in step 1 and allow the motor to
operate until it stops on its own.
vertilux.com
8
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
No. 4
ON
and
in the
Case #1
ON
position.
3
to release the chain
Case #1
, keep pressing either
you selected in
wall control
on the
.
again. At this
opposite direction
in the
position.
COVER
or
Case #2
depending on your situation.
(fig.
3).
Case #2
or
depending on your situation.
RED OR BLUE
BUTTON IS UNLOCKED
GEAR 1 (fig.
and remove
DIRECTION
BUTTON
STOP
BUTTON
RED OR BLUE
BUTTON IS
UNLOCKED
OPPOSITE DIRECTION
BUTTON
3).
Publicidad
Tabla de contenido
