DragonTouch Vision 1 Manual De Instrucciones página 10

VIDEO
To record Video, verify the camera is in Video mode.
To start recording:
Press the Grey Video Button. The camera will emit one beep and the camera light will
flash while recording.
To stop recording:
Press the Grey Video Button again. The camera will emit one beep and the camera light
will stop flashing while recording.
PHOTO
To capture a photo, verify the camera is in Photo mode.
To take a photo:
Press the Red Photo Button. The camera will emit a camera shutter sound.
CR2032 BATTERY REPLACEMENT FOR VISION 1 REMOTE
1. Use a 1.8mm Phillips tip screwdriver to remove the 4 screws on the back cover of
the remote, allowing you to open it.
14
2. Remove another 4 screws on PCB board.
3. Lift the PCB board and slide out the battery, as shown in the picture.
Note: Do NOT rotate the PCB board to avoid reversing the camera and video button
functions.
4. Install the new battery, keeping the "+" pole facing up.
5. Install all 4 screws back onto the PCB board.
6. Install all 4 screws back into the cover.
15