Levelling The Stove; Connection To Systems; Electrical Connection; Fuel Optimisation - CASATELLI FILIPPO 12 E1C Generalidades - Advertencias - Instalación - Mantenimiento

5.6 LEVELLING THE STOVE

The stove must be levelled using a spirit level and
by adjusting the feet (where included) (Fig. 5.10).
A B = Spirit Level

5.7 CONNECTION TO SYSTEMS

5.7.1 Electrical connection

Just connect the stove to the electrical system using
the plug provided.
The electrical connection (plug) must be easily
accessible even after installing the stove.
The power cable must not be come into
direct contact with the hot parts of the device.
If the power cable is damaged, it must be replaced
technician in order to prevent any risk.
5.7.1.1 Earthing
circuit breaker in accordance with the laws in force
(Fig. 5.11).
The exhaust fume duct must have its own earth
connection.

5.8 FUEL OPTIMISATION

(type of installation, operating and maintenance
conditions, type of pellets, etc.)
be optimised.
Generally speaking, if at the end of combustion,
there is a lot of residue in the burn pot, you
solution.
Refer to paragraph 10.3.5 "Fuel optimisation".
6

MAINTENANCE

centre)
6.1 MAINTENANCE
Maintenance operations must be performed by an
authorised technical assistance centre.
Before performing any maintenance operation,
take the following precautions:
- Make sure that all the parts of the stove are
cold.
- Make sure that the ashes are completely
extinguished.
- Use personal protective equipment provided
for by Directive 89/391/EEC.
- Make sure that the general line switch is turned
- Make sure that the power supply cannot be
accidentally reactivated. Remove the plug from
the wall socket.
44
-
-
004778350 - 16/07/2020
Always use appropriate equipment for
maintenance.
Once the maintenance or the repair operations
are completed, before re-commissioning the
stove, install again all the protections and
restart all the safety devices.
Fig. 5.10
Fig. 5.11