LaserLiner MultiMeter-Pocket Manual De Instrucciones página 13

Safety instructions
Dealing with electromagnetic interference
• The measuring device complies with safety and electromagnetic
compatibility regulations and limits in accordance with the Low
Voltage Directive 2014/35/EU and electromagnetic compatibility
regulations in accordance with the EMC Directive 2014/30/EU.
• Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards or
interference or be subject to hazards or interference.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Remove the battery(ies) before
storing for longer periods. Store the device in a clean and dry place.
Device description (see Fig. E)
1 Rotary switch to set
the measuring function
2
3 Switch over measuring function
4 LCD
5 Sensor (non-contact
voltage detector)
6 Indicator (non-contact
voltage detector)
7 Holder for test prods
8 Hold actual measured value
9 Measuring contacts:
red „+", black „–"
10 Test prods
AUTO OFF function
In order to preserve the batteries, the meter switches off
automatically if it is left idle for 15 minutes.
Insertion of batteries (see Fig. F)
1
Open the battery compartment and insert batteries according to
the symbols. Be sure to pay attention to polarity.
Attaching the test prods (see Fig. G)
2
In order to avoid the risk of injury, the test prods must always be kept
in the holder on the rear of the meter when not in use and during
transport.
MultiMeter-Pocket
A Measured value display
(3.5 segments, 1999 digits)
B Negative measured values
C Direct (DC) or alternating (AC)
variables
D Automatic range selection
E Diode test
F Continuity test
G Actual measurement is retained
H Low battery charge
I Measurement units:
mV, V, A, mA, Ohm,
kOhm, MOhm
Display: O.L: Open line/
not closed or measuring range
exceeded
13
EN