Maintaining Multi-Channel Pipettes - StarLab ErgoOne Manual De Usuario

7.2 Maintaining
Multi-Channel Pipettes
The figures shown below refer to the 100µl model. They may differ
slightly for other pipette models.
Changing the O rings
(100µl and 300µl models only)
O-rings for the pipette cone are removed and replaced using the
optional auxiliary tool (see section 8 Ordering Information).
Disassembling the lower
housing of the pipette
• Fully unscrew the lower housing
turning clockwise (Fig. 9).
• To remove the tip ejector
finger and thumb on either side of the tip
ejector, just below the ejector fixing
will allow you to slightly lift the ejector fixing
which will release the tip ejector
6
• Pull both clips
housing through 180° (Fig. 10).
Fig. 10
18 ErgoOne
squeeze with
5
down and rotate the lower
17
User Manual
®
by
16
. This
6
.
5
Fig. 9