Parts And Operating Controls - Bosch MMBH4 Serie Instrucciones De Uso

Parts and operating controls

High-speed motor block
The blender is equipped with a high-
speed motor, enabling more than 30,000
revolutions per minute. This not only
provides particularly fast and fine blending
results but also makes it possible to
heat food. Using the Soup automatic
programme, for example, a hot soup can be
made from cold ingredients.
Note: At the max speed setting, the blender
runs at the highest speed when using the
Pulse button and with certain automatic
programmes. In order to prevent unwanted
heating of food, process the ingredients for
a shorter time or at a lower speed.
"Power" on/off switch
To switch the appliance on and off.
Status display
To display the appliance status and as
a mark for the zero setting of the rotary
selector.
Display
Display lights up: appliance is switched
on and ready for use
Display flashes:
– fault in the appliance
– Blender jug is not correctly positioned
or has become detached
– Rotary selector not at zero setting
when switched on
– after interruption of the power supply
– longer than 5½ minutes of continuous
operation (manual mode)
Rotary selector
For continuous adjustment of the blender
knife speed.
Settings
Zero setting (mark points to the status
display) = standstill
min Lowest speed
max Highest speed
Parts and operating controls
Caution!
When the appliance automatically turns off
after 51/2 minutes of continuous operation at
the max speed setting, only use the max
speed setting for another 1-2 minutes at
the most after turning the machine back on.
Otherwise, the food may heat up too much
and damage the container.
Notes:
– The status display flashes if the rotary
selector is not at the zero setting when
switched on, if the blender jug has
become detached, or if the electricity
supply has been interrupted. Turn the
rotary selector first to the zero setting
and then continue.
– The rotary selector setting does not
affect the use of the Pulse function.
Pulse button
For switching to the maximum speed
for a short time. The appliance works at
maximum speed while the Pulse button is
pressed.
Note: The function cannot be used while an
automatic programme is running.
Programme selection buttons
with LEDs
For selecting and starting automatic
programmes. X "Automatic programmes"
see page 19
All LEDs light up after switching on. The
selected programme will start after pressing
the button and the appliance will run
automatically.
Blender jug
For processing up to 2 litres of food. The
blender jug is made of Tritan. Tritan is an
unbreakable plastic with no discernable
taste or smell.
Caution!
Do not expose the blender jug to
temperatures above 80°C.
Lid with locking cap
To securely close the blender jug
during processing. To add chopped or
liquid ingredients, turn the locking cap
anticlockwise and remove.
en
17