ESYLUX PD 360i/8 DALI ADR Manual De Instrucciones página 14

Button
The presence detector is equipped with a connection for an external
button. This can be used to manually switch the switching channel on
or off (sampling time <1s) and/or to dim it (sampling time >1s).
GB
6 • SETTINGS
Setting elements (Figs. 4.1 to 4.5)
HEX coding switch (Fig. 4.1)
The detector can be assigned an address with the Hex switch. See
chapter 4. Start-up.
Light value (Fig. 4.2)
4 fixed light values can be set (from 10 to 2,000 lux) and automatic
read-in of the current light value.
The light set value can either be changed with the potentiometer or
the remote control.
If the preset lux value is reached, it can be stored with the eye
function. This is indicated by a rapidly flashing LED. The lighting will
be switched off and the LED will flash slowly for 25 seconds. The
LED and lighting will then be switched on for 5 seconds. When the
lighting and LED are switched off again, the teach-in process will be
successfully completed.
Switch-off delay time (Fig. 4.3)
5 fixed switch-on times can be set (from 10 seconds to 30 minutes)
and test function (2 seconds).
14
Switch-off delay time, orientation light (Fig. 4.4)
4 fixed switch-on times (from 5 min to 15 min) and
Luminous efficiency of the orientation light (Fig. 4.5)
4 fixed light values from "OFF" to 30%.
7 • FUNCTIONS
Fully automatic mode
The light channel will switch on automatically, depending on the preset
light value and detection of movement. This will remain on for as
long as movement is detected and as long as the ambient light value
does not exceed the preset light value. If no further movement is
detected, the switch-off delay time starts. The channel can also be
manually switched on or off using the button. The device is preset to
fully automatic mode.
Semi-automatic mode for light channel
Switched on/off manually using the button. This lighting will remain
switched on for as long as movement is detected and as long as the
ambient light value does not exceed the preset light value.
Dimmer function
To adapt the current light value to the desired light settings, the
artificial light can be dimmed up or down automatically.
∞
.