Pentax HP Manual Del Usuario página 42

1. IDENTIFICATION, PACKING, SHIPMENT AND STORAGE
1.3 • LIFTING AND HANDLING
Packed pumps can be lifted and transported by fork lift trucks or
by hoists (see figure 5). All pump units with steel baseframe are
equipped with the holes for crane lifting.
ATTENTION!
The chosen trucks must be suitable for a safe lifting
and handling, considering the dimensions and
weights reported on the packing. (see figure 3).
ATTENTION!
Pump units must be handled only by authorized and skilled personnel.
1.4 • STORAGE
Packed pumps and units must always be kept in a covered, dry and protected
environment with temperatures between – 10°C and + 40°C avoiding direct expo-
sure to sunlight (Fig.6).Where pumps and units are to be stored for some
time, they should be rotated at least twice each month using a suitable tool.
In case of over 6 month storage, always contact the manufacturer. As for the
protection against corrosion, the external parts of the pump can be oiled and
greased.
1.5 • PACKING, STACKING
The type of packing being utilized permit the possibility of stacking up to 2 crates
on top of each other inside the warehouse or into truckbodies, provided that
they are properly piled and insured against falling (Fig.7).
1.6 • UNPACKING
When the goods arrive, please check if the parts have not been damaged during
transportation and verify every part listed in the delivery note (please inform the
manufacturer about possible problems or damages).
Unpack carefully taking all the necessary precautions in order to avoid any dam-
age to persons or pump parts (during the unpacking, please do not let the parts
fall from the crate).
1.7 • PACKING DISPOSAL
The wood of crate or the wood of pallet can be re-used or recycled in accord-
ance with the laws in force in the country where the pump is installed. Other
materials like strap and plastic have to be disposed in accordance with the laws
enforced in the country.
Pump
7
Motor
Base