Test Mode - Technoline BC-700 Manual De Instrucciones

about 1 second to activate the mode change. The subsequent pressing of the mode key
will enable to toggle between the "Charge", "Discharge", "Test" and "Refresh" mode.)
Then user may also select different discharging current by pressing the CURRENT key
(see "Note" in Discharge mode and Table 2), within 10 seconds after inserting the
batteries. (Or the display will blink once to indicate the end of setting and the current
cannot be changed afterward.)
It may take up to several days to finish the refreshing process, depending on the
selected discharging current.
The maximum refresh current is 350 mA.

TEST MODE

In Test mode the rechargeable batteries will first be fully charged and then discharged to
determine the capacities. Finally, the rechargeable batteries are charged up again and the
capacity in (mAh) of (Ah) will be estimated and shown after the discharging ends.
By pressing the MODE key within 10 seconds after inserting the rechargeable batteries, the
Test mode can be selected. (The mode key shall first be pressed and held for about 1 second
to activate the mode change. The subsequent pressing of the mode key will enable to toggle
between the "Charge", "Discharge", "Test" and "Refresh" mode.).
41