Dash Disassembly - Metra 95-7377B Instrucciones De Instalación

1. Open the glove box and remove the
trim at the top of the opening, and
then remove the (2) Phillips screws
exposed. (Figure A)
2. Unclip the trim that runs along the
dash from the right side A/C vent
to the steering column, and then
remove the (2) Phillips screws
securing the A/C vent/hazard panel.
(Figure B)
3. Unclip and remove the right side
trim panel from the center console,
and then remove the (1) Phillips
screw securing the A/C vent/hazard
panel. (Figure C)
4. Unclip the A/C vent/hazard panel,
disconnect the hazard switch, and
then remove the panel. (Figure D)
5. Using caution not to break the
panel, carefully unclip and remove
the radio trim panel. (Figure D)

Dash Disassembly

(Figure A)
(Figure B)
95-7377B
Note: There are (8) clips that attach
the panel to the vehicle: (2) at
the top-middle, (2) at the bottom
corners, (2) at the top corners, and
(2) in the center (these 2 are only in
non-nav models). (Figure E)
6. Remove the (4) Philips screws
securing the radio and then remove.
Continue to Kit Preparation
(Figure D)
2
(Figure C)
(Figure E)