Setting - Automatic Bidet Wand Cleaning - Kohler K-3900 Guia Del Usuario

Setting - Automatic Bidet Wand Cleaning

Running the Clean Cycle
NOTE: The cleaning cycle is a two part process. The wand is first rinsed with water. It is then treated with
UV light. If the toilet is used during the cleaning process, the process is stopped.
Select [settings].
Select [cleaning].
Select [UV clean wand].
To run the clean cycle immediately, select [run clean cycle]. Then select [ok]. The clean cycle takes
approximately 45 minutes.
Select [home] to return to the main screen or [back] to return to the previous screen.
Scheduling the Clean Cycle
NOTE: During the clean cycle, the bidet wand will extend and retract. This is normal.
Select [settings].
Select [cleaning].
Select [UV clean wand].
Select [set schedule]. The next screen is the start time for the clean cycle.
Use the up and down indicators to adjust the hour and minute to the time you desire the toilet to
begin the clean cycle.
Select the radio button for the [am] or [pm] option.
Select [next]. The next screen is the end time for sleep mode.
1132336-5-B 30 Kohler Co.