Connect The Power Supply - TEMPUR-PEDIC Ergo Smart Base Manual De Instalación

SET UP THE BASE
32
STEP 1
Identify the head and foot of the base
and ensure it is oriented correctly.
The logo is located on the foot end
of the base.
STEP 2
Remove the packaged components
(electronics bag with power supply and
remote control; legs bag; instruction
manuals and QR code sheet) and
mattress retainer bar from the underside
of the frame.
STEP 3
Screw the legs into the base. Do not
overtighten.
STEP 4
Locate the QR code sheet. Set it aside
for later. The customer will need this QR
code later in order to connect to the
Sleeptracker app.

CONNECT THE POWER SUPPLY

STEP 5
Untie the bundled power supply cable
(attached to the activated carbon pouch
near the head of the base). Remove and
discard all carbon pouches.
STEP 6
Connect the power supply cable to the
power supply from the electronics bag.
STEP 7
Place the base up on its legs.
• Two people are required.
STEP 8
Plug the power supply into a surge
protector (not included) connected to a
power source. The LEDs under the bed
will blink.
33