TEMPUR-PEDIC Ergo Smart Base Manual De Instalación página 18

PLACE THE SLEEPTRACKER SENSORS
Secure the sensor with the Velcro straps and secure any excess sensor
wire in the rubber conduits.
• The sensor should not be inserted vertically, halfway, or under the
Velcro strap on the edge of the base. The connector of the cable should
be tucked into the pocket. No part of the sensor should be visible.
34
STEP 9
Install mattress retainer bars: slide the
left side of the bar into the bracket, then
pull the retainer bar over the opposite
bracket and insert the right side of the
bar into the opening.
STEP 10
Using the remote, move the head of the
base into its full upright position.
STEP 11
Move to the head of the bed. Untie the
Sleeptracker sensors and insert them,
white tape side towards you to ensure
the sensor is face-up, into the pockets
at the head of the base. Be sure to
insert all the way into the pocket.
CUSTOMER CONNECTS TO THE SLEEPTRACKER APP
STEP 12
Confirm that the LED on the white
Sleeptracker processor is blinking
green. This may take up to 90
seconds.
• This indicates that the processor is
powered up and ready to connect
to a WiFi network.
35