Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.) Add 1 teaspoon of 2-stroke oil to the combustion chamber. Pull the
starter pull cord
several times in order to wet all mechanical parts
with oil. Replace the spark plug.
NOTE
■
Store the appliance in a dry place and away from possible ignition
sources.
Start-up after storage
1.) Remove the spark plug (see section "Spark plug maintenance").
2.) Pull the starter pull cord
quickly in order to remove any excess oil
from the combustion chamber.
3.) Clean the spark plug and observe the correct electrode gap on the
spark plug.
4.) Fill the fuel tank
. See the section "Fuel and oil".
Transporting
■
If you are planning to transport the appliance, empty the fuel tank
as explained in the section "Storage".
Troubleshooting
Motor unit
Problem
Possible cause
The engine does
Incorrect start-up process.
not start.
The engine starts
Incorrect adjustment of the
but does not run
choke lever
at full power.
Contaminated air filter.
The engine does
Incorrect spark plug gap.
not run smoothly.
Soot deposits or
Incorrect carburettor adjust-
wetness on the
ment.
spark plug.
Pole pruner
Problem
Possible cause
Motor is running,
Hedge trimmer attachment
or pole pruner attachment
saw chain
is not connected properly
does not move.
to the motor unit.
No work pro-
Saw chain
gress.
heating or is sagging.
Hedge trimmer
Problem
Possible cause
Motor is running,
Hedge trimmer attachment
blades do not
or pole pruner attachment
move.
is not connected properly
to the motor unit.
FBK 4 A1
Remedy
Follow the instructions
regarding starting.
Set the choke lever
.
to "
".
Clean air filter.
Clean the spark plug
and adjust the spark
plug gap or replace
the spark plug.
Clean spark plug or
replace it with a new
spark plug.
Remedy
Check assembly.
Top up the oil or reg-
dry/over-
rind, replace or tighten
the saw chain
.
Remedy
Check assembly.
Maintenance interval
Pole pruner
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and
longer daily working hours, the given intervals are to be reduced corres-
pondingly.
Appli-
Action
Before
ance part
starting
work
Lubricat-
check
ing the
X
chain
Saw
check and
note sharp-
X
chain
ness
check
chain
X
tension
sharpen
Guide
check
(wear,
X
rail
damage)
clean and
turn
deburr
replace
Sprocket
check
replace
Hedge trimmer
The figures given here are based on normal operating conditions. In the
event of more difficult conditions, such as strong dust generation and longer
daily working hours, the given intervals are to be reduced correspondingly.
Appli-
Action
ance part
Cutting
visual inspection
blades
clean
Spare part orders
Ordering spare parts
The following information should be provided when ordering spare parts:
■
Type of appliance
■
Item number of the appliance
■
Device ID number
Current prices and information are available at
www.kompernass.com
Weekly In the
In the
As re-
event
event
quired
of
of dam-
faults
age
X
X
X
X
X
X
X
X
Before
After
As re-
starting
com-
quired
work
pletion
of work
X
X
X
69
GB
MT
Publicidad
Capítulos
Tabla de contenido
