Step 12 Install Door And Drawer Panels - Monogram ZIW303NPPII Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR SINGLE UNIT (cont.)

STEP 12 INSTALL DOOR AND DRAWER PANELS

1. Remove all door and drawer panel hardware and trim
from the unit.
Item Quantity
Panel Brackets 12
Phillips Machine 34
Screws (for use
with SS Panel
Accessory)
Allen Hex Socket 12
Head Screws
Washers 12
Door Trim 6
Trim Caps 12
Allen Wrench 2
2. Attach A1 - F1 brackets to the door panels in the
locations identified below. Custom panels must have
pre-drilled holes as shown in Door Panel Templates:
31-1000149, 31-1000150, 31-1000151, 31-1000152.
If you purchased an SS Panel Accessory, use the
Phillips machine screws to attach the brackets to the
SS door panels. For custom panels, use an appropriate
wood screw.
D1 A1
Refrigerator
Panel
G1
G1
E1 B1
Freezer
F1
C1
Panel
A1
D1
Customizable
Panel
E1 B1
Back View of Panels
3. If you had custom handles made and they are not
currently attached to your panels, do so now.
4. Remove the screw caps from the adjustment pins on
the doors.
Installation Instructions
Do not tighten the screws, you will
do that after assembly process
and left to right alignment.
5. Open the refrigerator door to attach the refrigerator
panel.
6. Rest the refrigerator panel on the refrigerator door
by aligning the hooks on the panel brackets with the
adjustment pins on the door.
7. Fasten the panel to the refrigerator door in four
locations using the hardware shown below. Do not
tighten the screws. Screws will be tightened after panel
alignment.
8. Shift the panel side to side to ensure even gaps with
the adjacent cabinetry on both sides.
9. Use an allen wrench to
adjust the refrigerator
door panel depth
and height to align
with the adjacent
cabinetry. There must
be a minimum 1/8" gap
between the panel and
the adjacent cabinetry.
18
Align at top
and bottom
Screw and
Washer
Tighten one screw per bracket.
The other screws will be
tightened at the end of the
alignment process.
Depth Adjustment
Vertical
Adjustment
31-1000169 Rev. 4