Step 3 Reverse Door Swing (Unit 1) - Monogram ZIW303NPPII Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
STEP 2 INSTALL HEATER
UNIFICATION KIT(S) TO UNIT 2
(cont.)
Move the two (or more) units together and align the
front.
Attach units 1 and 2 at the back using screws and
nuts from the
remaining units in the same way.
Joining
Bracket
Top of Unit
Installation Instructions
Joining
Bracket
Spacer Clip
Top of Unit
STEP 3 REVERSE DOOR SWING
(UNIT 1)
Remove the top and bottom trim covers from unit 1.
Top Trim Cover
Bottom Trim
Cover
WARNING
Follow all steps when reversing
the door swing. Failure to follow these instructions,
leaving off parts, or overtightening screws, can
lead to the door falling off and result in injury and
property damage.
1. Pull the front tape down far enough to open the
refrigerator door.
WARNING
Point Hazard
This next step is important for safe handling of an
unloaded hinge. Do not skip step 2.
2. Release the hinge springs by using a Torx T-20
wrench to loosen the Torx screw from | to 0 on both
hinges. Close the door.
24
Door Hinge Pinch
31-1000169 Rev. 4