Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
18
17.1 Instructions for installation of the Roller System
WARNING!
Installation operations must be performed by qualified personnel.
WARNING!
All responsibility is declined for malfunctions or damage caused by incorrect
installation and placing in operation by unqualified personnel.
Follow the steps below with care to install the roller system accessory (POA3xx):
•
Place the armchair in operation and put it in the lift position;
•
Disconnect the plug;
•
Detach the two front wheels using a standard 10 mm wrench;
•
Tip the armchair forwards;
Fig.2
•
Insert the roller system (supplied already partially assembled) into the steel base of the
armchair (fig. 2);
•
Line up the four holes on the front of the armchair frame base with those present on the
roller system supports and lock them in place with the four screws and nuts provided (Figs.
3 and 4);
Fig.5
•
Take the components shown in Fig.5;
•
Insert the long pin on the wheel support (Fig. 6);
•
Insert the pin and wheel in the rear right-hand plate of the frame (Figs. 7 and 8);
•
Insert the stop on the pin on the outer side of the frame;
•
Insert the washer on the pin from the inner side of the frame;
•
Assemble the roller system rod on the pin previously installed (Fig. 9) and insert the stop on
the inner side as well;
Fig.3
Fig.6
Fig.4
Fig.7
Fig.8
Publicidad
Capítulos
Tabla de contenido
