Mopedia PO300M Manual De Instrucciones página 43

Fig.9
• Take the components shown in Fig. 10;
• Insert the short pin on the wheel support;
• Insert the pin and wheel in the rear left-hand plate of the frame (Fig. 11);
• Insert the washer on the pin from the inner side of the frame;
• Insert the stops on both ends of the pin;
Fig.12
• Take the steel bar with the two remaining pins and place it close to the frame plates, turning
it so that the black rubber tips face downwards;
• Insert the right-hand curved rod of the roller system inside the hole on the bar (Fig.12);
• Insert the pins to block the bar on the armchair frame plates;
• Insert the stops on both pins (Fig.13);
• Tip the armchair back into its normal position;
• Connect the armchair to the mains current and return it to the upright position.
Fig.10
Fig.13
Fig.11
19