Before First Use; Operation - Klarstein Zermatt Manual Del Usuario

EN
14

BEFORE FIRST USE

• Prior to installation, please ensure that your power-outlet is suitable for your
fireplace against both voltage and capacity.
• Your fireplace may emit a slight, harmless odor during its first use. This odor is a
normal condition caused by the initial heating of internal fireplace parts and it will
not occur again.
• It is normal for fireplace to make rattling sound for a short duration of time, during
its first use.
• If your fireplace does not emit heat, please ensure the fireplace Switch is on. For
further information, please refer to Troubleshooting section of this manual.
Helpful Advice Before Installation
• Please retain all packaging until you have checked and counted all the parts and
other package contents.
• It is recommended to place your fireplace near an existing outlet, for ease of
electric connection.
• Store your fireplace in a dry, safe and dust-free place while drilling, for fireplace
installation.
• Do not attempt to wire new outlets or circuits. To reduce the risk of fire, electric shock
or injury to persons, always have a licensed electrician perform maintenance and
other repairs.

OPERATION

This fireplace can be operated with the switches located on the rear panel of the
fireplace.
• Plug the fireplace to an power outlet.
• The controls are located on the rear panel of the fireplace .The ON/OFF switch
must be first switched ON. This will turn the flame effect ON.