B.A. International OPTIMA 10 BASES10 Modo De Empleo página 6

5.1.1 Full power mode: screen shows 01, LED works in full power.
5.1.2 Ramping mode: screen shows 02, LED turns from weak to
stronger, and reaches the highest power in 5 seconds.
5.1.3 Pulse mode: screen shows 03, LED works in the mode of pulse.
5.2 Lightly press the time button to choose the solidification time. 9
working time modes are available: 3,5,10,15,20,25,30,35,40 seconds.
5.3 During the operation, aim blue light at the position needing
solidification. Press the ON/OFF switch, a "beep" sound will occur, the
LED starts to work under the selected mode. Then it counts down to "0"
second to end the solidification.
5.4 During operation, the blue light can be stopped by press the power
button at any time.
5.5 Low power detect circuit is fixed inside of the main unit, when low
power is detected, the indicator of the main unit will wink, please charge
in time.
5.6 When the battery needs to be charged, connect the plug of the adapter
into the AC100V~240V power supply. Then connect the output plug
of the adapter to the input plug of the pedestal, and then the indicator
turn to green, that means the pedestal is standby. Put the main unit to
the charging point of the pedestal, the indicator turn to yellow, and the
curing lights starts charging. When charging is finished the indicator
turns green.
5.7 After the operation, please clean the fiber with calico in order not to
4