DuPont QuickTwist WFQT13000 Serie Instrucciones De Instalación página 5

STEP 2
Mount the Faucet for Filtered Water
NOTE: The Faucet for Filtered Water in this package is designed to fit a 9/16" hole. Most standard sinks come with 1-3/8" or 1-1/2" diameter
water sprayer holes that can be used for mounting the Faucet. If the pre-drilled holes cannot be used or are not in the desired position, a new
hole must be drilled using either a 9/16" or 5/8" drill bit to accommodate the Faucet. The Faucet for Filtered Water base should be positioned
securely on a flat surface with adequate space for proper function. Consider convenience and appearance of the faucet before installation.
IF YOUR SINK DOES NOT H VE W TER SPR YER HOLE, GO TO
1
In order to prevent parts and materials from falling down the drain, line the sink with newspaper or a towel.
2
pply masking tape to the area to be drilled in order to prevent scratching the sink surface or countertop if the drill bit slips
during operation.
3
Using a center punch, mark the drill hole. Use the 1/4" drill bit to make a pilot hole. Then use the 9/16" or 5/8" drill bit to drill the final
hole. Drill completely through the sink or countertop and smooth the rough edges with a file.
C UTION
Safety glasses and a respirator are
recommended for this process, as it
may produce dust that can cause
severe irritation if it is inhaled or
comes in contact with eyes.
NOTE: Make sure that the Faucet for Filtered Water is assembled. The Faucet for Filtered Water Spout should be inserted into the Faucet for
Filtered Water Body and the retaining nut should be tightened until snug.
4
Guide the Black Rubber Gasket
countertop hole. Make sure the Faucet for Filtered Water sits flat on top of the sink or countertop surface.
5
From underneath the sink, slide the Metal Lock Washer
G
Stem Nut all the way up the Faucet Stem until it is flush with the Metal Lock Washer. Screw until it is slightly snug and check
to make sure the faucet spout is in the proper position. Using fingers, tighten the nut to secure the Faucet for Filtered Water to
the sink.
NOTE: Do not tighten the Faucet for Filtered Water Stem Nut with pliers as it may strip the Faucet Stem threads.
WFQT13000 & WFQT13500 Series
1
. IF YOUR SINK DOES H VE
DO NOT DRILL THROUGH N LL-PORCEL IN OR C ST IRON SINK. If installing on an all-porcelain
or cast iron sink, the faucet must be mounted in a pre-drilled sprayer hole or through the countertop
next to the sink. If the countertop must be drilled, make certain that the area below the drilling
location is free of wiring and pipes. lso, make sure that there is sufficient room to make the proper
connections to the bottom of the faucet mount. DO NOT DRILL THROUGH COUNTER TOPS MORE
TH N 1" IN THICKNESS OR COUNTERTOPS M DE OF TILE, M RBLE, GR NITE OR SIMIL R
SUBST NCE. Consult with a plumber or the countertop manufacturer for assistance.
E
onto the threaded Faucet for Filtered Water Stem. Slip the threaded Faucet Stem into the sink or
F
up the Faucet for Filtered Water Stem. Then screw the plastic Faucet
W TER SPR YER HOLE, GO TO
C UTION
5
2
1
F UCET FOR
FILTERED W TER
4
.
SPOUT
B SE
E
F
G
V4.0