Install The Corner Post; Attach The Receptor/Bench; Attach The End Panel - Kohler K-1315-H Guia De Instalacion

Install the Corner Post

Three
Large
Holes
First position and
install the corner post
in the front corner of
the whirlpool
3. Install the Corner Post
CAUTION: Risk of product damage. Do not force the corner post into position, or use it to adjust the
whirlpool height or level.
- Position the corner post in the unsupported front corner of the whirlpool so the three large holes are toward
the side of the unit. Identify the predrilled holes in the wood block on the underside of the whirlpool. Secure
the corner post to the block with the two screws provided. Tighten securely.
- If it is necessary to adjust the height of the corner post, loosen the two hex nuts securing the corner post top
bracket in place. Slide the adjustment bracket up or down as needed to achieve a good fit. You may need to repeat
this step for the bottom bracket. Hand tighten the hex nuts.
- If this whirlpool will be assembled to a receptor and bench, proceed to Attach the Receptor to the Whirlpool"
below. If the whirlpool will be installed alone, proceed to the installation instructions packed with the optional
apron and end panel. Then proceed to Install End Panel" below.
4. Attach the Receptor/Bench to the Whirlpool (Whirlpool/Receptor
Combinations Only)
- If you have not yet assembled the bench to the receptor, do so now by following the instructions packed with the
receptor. Then lift the whirlpool slightly along the outside end, and insert the bench top flange into the groove
underneath the whirlpool rim.
- Position the bench so the side flange is behind the corner post. Align the three fastener holes in the bench with the
holes in the corner post, and loosely fasten the bolts and hex nuts.
- Use a carpenter's square to square the corner post, whirlpool, receptor, and bench with the floor. Secure the corner
post firmly to the floor with two screws.
5. Attach the End Panel to the Whirlpool (Whirlpool Only Installations)
- Lift the whirlpool slightly along the outside end, and insert the end panel top flange into the groove underneath
the whirlpool rim.
- Position the end panel so the side flange is behind the corner post. Align the three fastener holes in the end panel
with the holes in the corner post, and loosely fasten the bolts and hex nuts.
- Use a carpenter's square to square the corner post, whirlpool, and end panel with the floor. Secure the corner post
firmly to the floor with two screws.
Kohler Co.
Whirlpool
Front
Corner
Wood
Block
Predrilled
Holes
Adjustable
Bracket
Screw
Then adjust
the corner
post height
by loosening
the hex nuts
5
Attach the Receptor/Bench or End Panel
Top
Flange
Receptor/Bench
or End Panel
Side Flange
Screw
Three
Fastener
Holes Corner
Post
Screws
Fit the top
flange into the
groove
Washer
Hex Nut
Lift the
whirlpool
slightly, and
insert the
receptor/bench
or end panel
A
1012312-2-