EN
Setting Self Clean
The Self Clean key controls the self-cleaning fea-
ture. If you are planning to use the oven directly af-
ter a self-clean cycle remember to allow time for the
oven to cool down and the oven door to unlock. This
normally takes about one hour. A 3 hour self-clean
cycle will actually take about 4 hours to complete. It
is recommended to use a 2 hour self-clean cycle for
light soils, a 3 hour cycle for average soils, and a 4
hour cycle for heavy soils.
To set the controls for a 3 hour self-cleaning
cycle to start immediately and shut off auto-
matically:
1. Be sure the clock is set with the correct time of
day and the oven door is closed.
2. Press Self Clean. CLn and 3:00 HR will show in
the display. The control will automatically clean
for a 3 hour period (default self-cleaning cycle
time).
3. Press STarT. door Loc will appear, a beep will
sound, and the word DOOR and the (lock icon)
will flash; CLn will remain on in the display.
4. As soon as the control is set, the motor driven
oven door lock will begin to close automatically.
Once the door is locked, the DOOR indicator
light and lock icon will stop flashing and remain
on, and the oven icon will appear in the display.
Allow about 15 seconds for the oven door to lock
completely.
When the self-clean cycle is completed:
5. HOT will appear in the display. The time of day,
the word DOOR, and the lock icon will remain in
the display.
6. Once the oven has cooled for approximately 1
hour, door OPn will appear, and the word DOOR
and the lock icon will flash until the door un-
locks. The door can be opened, and the display
will show the time of day.
To stop or Interrupt a self-cleaning cycle:
If it becomes necessary to stop or interrupt a self-
cleaning cycle due to excessive smoke or fire in the
oven:
1. Press OFF.
CaUTION
To avoid possible burns, use care when opening the
oven door after the self-cleaning cycle. Stand to the
side of the oven when opening the door to allow hot
steam and air to escape.
Setting Delay Start Self Clean
To set the control for the self-cleaning cycle to
start at a delayed time and shut off automati-
cally (example: 3 hour self-clean cycle to start
at 4:30):
Be sure the clock is set with the correct time of day
and the oven door is closed.
1. Press Self Clean. CLn and 3:00 HR will show in
the display. The control will automatically clean
for a 3 hour period. If a 2 or 4 hour clean time is
desired, press Self Clean multiple times to toggle
between 2, 3, or 4 hours.
2. Press STarT. door Loc will appear, a beep will
sound, and the word DOOR and the lock icon will
flash. The letters CLn will remain on in the dis-
play.
3. As soon as the control is set, the motor driven
oven door lock will begin to close automatically.
Once the door has been locked, the word DOOR
and the lock icon indicator light will quit flashing
and remain on.
4. Press DELay STarT. Enter the desired start
time using the number keys 4 3 0.
5. Press STarT. DELAY, DOOR, and the lock icon
will remain on.
6. The control will start the self-cleaning at the set
start time for the period of time previously se-
lected. At that time, the icon DELAY will go out;
CLn and oven icon will appear in the display.
When the self-clean cycle is completed:
HOT will appear in the display. The time of day, the
word DOOR, and the lock icon will remain in the
display.
When oven cools approximately 1 HOUR, door OPn
will appear, and the word DOOR and the lock icon
will flash until the door is unlocked. The oven door
can then be opened, and the timer will revert back
to the time of day.
NOTE
If your clock is set with the (default) 12 hr display
mode, the delay start for a self clean can only be
programmed to start up to 11 hours and 59 min-
utes after the time showing in the display (be sure
to set the clock to current time before program-
ming a Delay Start). To set a Delay Start self clean
to begin 12 or more hours (maximum is 23 hours
and 59 minutes) after the time of setting, be sure
to first set the control in the 24 Hr display mode.
OVEN CONTrOLS
21