Customer Information For Acta - Siemens SIMATIC TS Manual De Producto

9.9

Customer Information for ACTA

Customer Information for ACTA
This equipment is compliant with Part 68 of the FCC regulations and requirements adopted
by ACTA. The label on the right side of this equipment also contains the product ID
(US: CO4DT10B022B3V3 for the TS Adapter IE -Modem). This ID must be submitted to the
telephone company on request.
The plug and jack used to connect this equipment to the circuit and telephone network at
your site must conform to FCC Part 68 regulations and requirements adopted by ACTA. A
compliant telephone cord and modular plug is supplied with this product. It is designed to be
connected to a compliant modular jack. See the installation instructions for details.
The REN is used to determine the maximum number of devices on a analog telephone line.
If the number of RENs on a analog telephone line is exceeded, the devices may not ring in
response to an incoming call. In most areas the sum of RENs should not exceed five (5.0).
Contact the local telephone company to ascertain the number of devices that may be
connected to a line, as determined by the total RENs. For products approved after July 23,
2001, the REN forms part of the product identifier that has the format for the TS Adapter IE -
Modem: US: CO4DT10B022B3V3.
REN is set to NAN. The user does not need to calculate the REN, but may not exceed a
maximum number of 8 ISDN terminals on the network termination.
The telephone company will notify you in advance if services are temporarily discontinued as
a result of your TS Adapter IE causing disturbances on the telecommunications network. If
advance notice is not deemed practical, the telephone company will notify the customer as
soon as possible. You will be advised of your rights of filing a complaint with the FCC.
The telephone company may modify its services, equipment, operations or procedures,
which could affect operation of your equipment. In this case, the telephone company will
notify you in advance, thus allowing you to adapt your equipment configuration for
uninterrupted service.
If you experience trouble with the TS Adapter IE and require repair or warranty information,
please contact
Siemens Johnson City - SIAC -
One Internet Plaza
Johnson City, TN 37604
If the equipment is causing disturbances on the telecommunications network, the telephone
company may ask you to disconnect the equipment until the problem is resolved.
Connections to a party line service are subject to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information.
If your premises are equipped with an alarm system which is connected to the telephone
line, ensure the installation of the TS Adapter IE does not disable your alarm system. If you
have questions about negative effects on your alarm system, contact your telephone
company or a qualified service point.
Note
Disruptions of the alarm functions of alarm equipment may occur not only as a result of faulty
installation, but also in situations where the TS Adapter IE is used as intended (dual channel
mode).
TS Adapter IE
Manual de producto, 11/2010, A5E00977707-03
Datos técnicos
9.9 Customer Information for ACTA
95