Kit Preparation - Metra 99-7343 Instrucciones De Instalación

From the factory radio trim panel:
1. Unclip and remove the hazard switch.
(Figure A)
2. If applicable, remove the (2) Phillips
screws securing the passenger air bag
light assembly. (Figure A)
3. Remove the (4) Phillips screws securing
the climate control panel. (Figure A)
Note: On the top of the climate control
panel there will be (2) small plastic
locater pins. These must be cut off to fit
properly into the kit.
4. Remove the (4) Phillips screws securing
each vent, and then unclip and remove.
(Figure A)
Continued on the next page
4

KIT PREPARATION

(Figure A)
|
1.800.221.0932 MetraOnline.com