Figure 86. Installing the 2.5-inch (x10) hard drive backplane
1. release tab
3. SD signal cable connector
5. SAS cable connector (2)
7. guide pin slot
Figure 87. Installing the 1.8-inch (x24) hard drive backplane
1. SD signal cable (3)
3. SAS cables (4)
5. guide pin
7. backplane
1. Install the hard drives in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related references
Instrucciones de seguridad
Obtención de ayuda
on page 202
Uso de los diagnósticos del sistema
160
Instalación y extracción de los componentes del sistema
on page 81
on page 179
2. SD signal cable
4. SAS cables (2)
6. guide pin
8. backplane
2. SD signal cable connector (2)
4. SAS cable connector (4)
6. guide pin slot
8. release tab (2)