Publicidad
Idiomas disponibles
Idiomas disponibles
27. From the kit contents, locate and select they yellow
16 AWG wire (II, Figure 22, Ref. 3). Cut the yellow 16
AWG wire in thirds, and strip the ends of the cut wires.
On each of the cut wires crimp a blue fork terminal (JJ,
Figure 22, Ref. 8) on one of the ends.
24
I I
28. Install the fork terminal end of each yellow wire (KK,
Figure 19a-b) on DC post 2 of 725 light relay 1, 2, and
3. Then, install the bare wire ends of the two black
wires into the open ports of the 5 port lever lock (LL,
Figure 19a-b) that was installed in Step 26.
25a
KK
725 Relay 1
725 Relay 2
10
25b
JJ
725 Relay
Connection Detail
29. Check and make sure all connections are secure and
tightened.
30. The wiring is now complete. Close the AC front panel,
reconnect the battery, start the engine and turn on the
lights to make sure all are operating correctly.
31. Once the unit is verified to be operating correctly,
re-install the rear door panel.
LL
KK
725 Relay 3
725 Relay 1
725 Relay 2
LL
KK
725 Relay 3
www.allmand.com
Publicidad
