Allmand 725 Instrucciones De Instalación página 5

8
Distribution Block 1
11. Loosen the screw on AC post 1 of 725 light relay 2 and
connect the fork terminal on the wire (K, Figure 9a-b)
leading from either Distribution block 1 or 2 into the
post. Tighten down the screw onto the fork terminal.
9a
J
Distribution Block 2
725 Relay 2
K
9b
725 Relay
Connection Detail
12. Install the stripped end of the remaining black wire (L,
Figure 10) with the new fork terminal into an open port
of Distribution block 2. If wire is red, install wire into
Distribution block 1 (Not shown). If a port is not open
select a larger port to install with another wire. To
install in the distribution block loosen the set screw for
the port that stripped end of the wire will be inserted
in. Make sure all the bare wire strands are in the port.
Tighten the set screw in the distribution block.
10
Distribution Block 1
13. Loosen the screw on AC post 1 of 725 light relay 3 and
connect the fork terminal on the wire (K, Figure 11a-b)
leading from either Distribution block 1 or 2 into the
post. Tighten down the screw onto the fork terminal.
725 Relay 2
K
Distribution Block 2
en
English
J
5