Allmand 725 Instrucciones De Instalación página 6

11a
11b
725 Relay
Connection Detail
14. If replacing Zettler relay 2, locate the 12 AWG wire
(L, Figure 12a-b) that is leading from the relay to
light switches 2, 4, and 6. If working from Zettler
relay 1 locate wire from light switches 1, 3, and 5.
Remove the three screws (M, Figure 12a), the 12
AWG wire, and buss bar (N, Figure 12a) from the
top of the switches. Discard the buss bar, and set
two of the screws aside as they will be used in Step
19. Depending on Zettler relay, re-install the wire and
screw onto light switch 1 or 2.
6
725 Relay 3
K
725 Relay 3
K
12a
Light Switch 5
L
M
N
12b
L
Light Switch
Connection Detail
15. On Zettler light relay 2, disconnect the 12 AWG wire
(O, Figure 13) from the AC light switch spade, and this
wire was just reconfigured on the light switch 2. On
Zettler relay 1, disconnect the wire leading from light
switch 1 from the same spade.
13
Zettler Relay
Disconnection Detail
Light Switch 3
Light Switch 1
Light Switch 2
Light Switch 6
Light Switch 4
Light Switches Detail
Light Switch 2
Zettler Relay 2
O
www.allmand.com