EuroSteam STONE GLIDE 6198 Manual De Instrucciones página 7

*Cleaning the boiler is important to the performance of the iron*
5. Using the brush
Hold the iron in vertical position. To facilitate the assembly, insert the accessory on half of
the plate. Slide the iron up to the tip so that the plate remains locked in the two guides. Put
the iron in hori ontal position. Place the rubber elastic band above the iron.
6. Cleaning
We recommend that the following cleaning instructions be carried out
every 2-3 months or if you notice any water drops leaking out of the
soleplate of the Eurosteam
Soleplate
Before cleaning the iron be sure that the unit is disconnected from the power supply and that
the iron is completely cooled down. Do not use abrasives on the soleplate. Deposits and
other residues on the soleplate can be removed with a cloth soaked in a vinegar and water
solution. Keep the soleplate smooth by avoiding contact with hard or abrasive surfaces.
Boiler Tank
For a quick cleaning... Fill the iron with water, using your measure cup, to ust below the ma
line. Place the safety cap on and tighten till closed, plug the unit into a power surge protec-
tion bar and allow the unit to heat up. When the indicator light shuts off, unplug the unit from
the power source and let sit for 10 minutes. Shake vigorously in all directions and allow to
cool for 10 minutes more. Unscrew safety cap and empty contents into a sink; holding the
unit away from you. Use caution as water may still be hot. You should see mineral deposits
(small white or grey akes) which is normal.
®
iron.
CLEANING YOUR EUROSTEAM ®
7