Operation Operating The Shade; Adjusting Alignment; Removing The Shade - Levolor Roman Shades Instalación

CONTINUOUS CORD LOOP BOTTOM-UP
•
Pull one side of cord loop to lower the shade to
the desired height. Pull the other side of the cord
loop to raise the shade to the desired height.
ADJUSTING ALIGNMENT AND FOLDS
To ensure the shade raises and lowers evenly, the roman bar clips on the back of the
shade may need to be adjusted. These clips are self aligning, however they can shift
out of alignment from time-to-time.
•
The shade should be adjusted to the fully lowered position.
•
Locate the cord route in the top of the headrail behind the shade.
•
On the back of the shade, adjust any roman bar clips by hand that are out of
vertical alignment with the cord location in the headrail.

REMOVING THE SHADE

•
Fully raise the shade.
•
Step 1: Use a flathead screwdriver and push downwards on spring tab and then
rotate the front headrail.
•
Step 2: While pushing back on the headrail, rotate the front of the headrail up.
Never force the spring tab beyond the back of the brackets.
Step 1
CAUTION: Hold shade firmly when removing. Failure to do so may result in
!
the shade falling and possible injury.
OPERATION | UNINSTALL
Bottom-Up Shade
Step 2
Cord Loop Lift Control
17