Outside Mount - Levolor Roman Shades Instalación

INSTALLATION
INSIDE MOUNT (IM)
STEP 3: INSTALLING THE SHADE
•
Hang the curved front side of the headrail on the front lip of the brackets.
•
Rotate the headrail backwards toward the window until a snapping sound is heard.
This will let you know the shade is engaged in the brackets.
•
Install the included operating handle by snapping it onto the front of the bottom rail;
in case of a top-down/bottom-up shade, snap a handle onto the middle rail as well.
CAUTION: Be sure the bracket and headrail are properly secured before
!
operating the shade. Failure to do so may result in the shade falling and
possible injury.
10
Cordless Lift Control
19-0050-030 Romans Install Guide-Cordless_F_070720.indd 10-11
Front lip
Front Lip
Spring tab
Spring Tab
Headrail
Headrail
OUTSIDE MOUNT (OM)
Bracket
Bracket
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: Before marking bracket locations, ensure that your bracket placement
will not interfere with any components inside the headrail.
IMPORTANT: The rear of the brackets must be flush against a flat mounting surface.
Do NOT mount brackets on curved molding.
•
Center the headrail over the window opening at the desired height.
•
Use a pencil to lightly mark each end of the headrail.
— Alternatively, measure the width of the headrail and use that width to mark
the headrail end points over the window opening.
•
Mark approximately 1 - 2" in from each end of headrail for the installation
bracket locations.
— Allow a minimum of ⁄ in. between the bottom of the installation bracket and the
1
4
top of the window molding.
•
With a pencil, mark the installation brackets or extension bracket screw locations
through the larger, oblong rear holes of the bracket, 2 screws per bracket.
•
Use a level to ensure all brackets are aligned.
•
If more than two installation brackets come with your order, space additional bracket(s)
evenly between the two end brackets, no more than 30" apart, mark drill hole locations.
INSTALLATION
11
Cordless Lift Control
7/7/20 9:11 AM