Assembling The Side Table; Mounting The Side Table; Installing The Flame Broiler Components - Pit Boss PLATINUM KC COMBO PB1285KC Manual De Instrucciones

Parts Required:
Screw (#B)
2 x
Installation:
• Attach M6x15 mm screws onto right side of the main chamber and leave
about 1/4 inch out.

17. MOUNTING THE SIDE TABLE

Parts Required:
1 x Side Table (#10)
Screw (#B)
3 x
Installation:
• Hang the right Side Table onto those two screws and then push ahead to
seat on it.
• Mount the Side Table to the Main Barrel / Hopper Assembly with another
three M6x15 mm screws.
• Tighten the screws to ensure they are completely secure.

18. INSTALLING THE FLAME BROILER COMPONENTS

Parts Required:
1 x Flame Broiler Main Plate (#32)
1 x Flame Broiler Slider (#33)
Installation:
• Insert the flame broiler main plate into the main grill, right side first.
Rest the flame broiler main plate on the built-in ledge (on the inside
right) of the main grill that directs grease towards the grease bucket.
Slide the entire piece to the left side, and the two slots on the flame
broiler main plate will fit into the rounded ledge above the fire pot. It
will sit slightly at a downward angle.
IMPORTANT: If the flame broiler main plate is on the base of the barrel,
it is installed incorrectly. The flame broiler main plate should sit at an
angle, with the left side sitting higher than the right. Poor installation of
this part may result in damage to your main grill barrel.
• Place the flame broiler slider on top of the flame broiler main plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust for
direct or indirect flame when cooking. Both flame broiler parts are lightly
coated with oil to avoid rusting when shipped.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
16
17
10
1
18
32
33
32
¼ IN
2
3
13